Step 8. Sealing The Wiring; Step 9. Adjusting The Camera; Connecting To A Video Monitor - Honeywell HD54IP User Manual

Installation and Setup

Step 8. Sealing the Wiring

Step 9. Adjusting the Camera

26
To prevent moisture from entering the housing, you should apply the appropriate sealant
around the conduit entry and mounting screws.

Connecting to a Video Monitor

The local video out connection (see
and should be used during installation to position, aim, and focus the camera, as needed.
Connect from the local video out connector on your camera to the video input connector
on your spot monitor.
Adjust the FOV (Field of View)
To adjust the your camera:
1. Verify that power is supplied to the camera.
Note Please wait approximately 60 seconds after connecting to a power source for
video to appear on the local video output.
2. Reinstall the gimbal by inserting the black tabs into the black clips on the enclosure
base.
3. Connect the supplied video cable to the local video out connector to view the video
signal on a standard monitor (see
connector).
4. Loosen the setscrew that locks the gimbal assembly in place (see
adjust the horizontal rotation.
5. Adjust the camera gimbal to the desired view.
6. Re-tighten the locking screw to lock the gimbal assembly in place.
7. Disconnect the video cable from the local video out connector after making all needed
adjustments to the camera (see also
Note Figure 2-6 illustrates the ways in which you can adjust your camera.
Figure 2-5 or Figure 2-6) is available as a test output
Figure 2-6) for the location of the local video out
Adjusting the Lens Focus
Figure 2-6) to
on page 27).