HD3 EQUIP Series H.264 Indoor High Resolution True Day/Night IP Dome Camera User Guide
Camera Installation
Preparing the Camera
Preparing the Mounting Surface
Document 800-07361V3 Rev A
11/2011
1.
Rotate the dome bubble counterclockwise
until it disconnects.
2.
Pull the turret to remove it.
3.
Rotate the camera counterclockwise until it
disconnects from the skirt.
4.
Set aside the dome bubble, turret, and
camera.
1.
Mark the mounting surface for screw holes and wire access hole.
•
Use the mounting template if you are surface mounting your camera. See
Mounting Template
•
Use the flush mount adapter plate as a template if you are flush mounting your
camera.
Figure 2-2
Surface Mounting Template
on page
69
Drill these holes for the
mounting screws.
Cut this hole, then pull the
power, audio, and alarm
wires through it.
Skirt
Camera
Turret
Dome bubble
Surface
19