Camera Installation; Preparing The Camera; Preparing The Mounting Surface; Figure 2-2 Surface Mounting Template - Honeywell EQUIP HD3MDIHX User Manual
Indoor high resolution true day/night ip dome camera ntsc/pal equip series
Hide thumbs
Also See for EQUIP HD3MDIHX:
- Quick install manual (2 pages) ,
- User manual (116 pages) ,
- Selection manual (16 pages)
Table of Contents
Advertisement
Installation and Setup
Camera Installation
Preparing the Camera
Preparing the Mounting Surface
18
1.
Rotate the dome bubble counterclockwise
until it disconnects.
2.
Pull the turret to remove it.
3.
Rotate the camera counterclockwise until it
disconnects from the skirt.
4.
Set aside the dome bubble, turret, and
camera.
1.
Mark the mounting surface for screw holes and wire access hole.
•
Use the mounting template if you are surface mounting your camera. See
Mounting Template
•
Use the flush mount adapter plate as a template if you are flush mounting your
camera.
Figure 2-2
Surface Mounting Template
on page
65
Drill these holes for the
mounting screws.
Cut this hole, then pull the
power, audio, and alarm
wires through it.
Skirt
Camera
Turret
Dome bubble
Surface
Advertisement
Table of Contents
