Camera Installation; Preparing The Camera; Preparing The Mounting Surface; Figure 2-2 Mounting Template - Honeywell EQUIP HD3MDIP User Manual

Installation and Setup

Camera Installation

Preparing the Camera

Preparing the Mounting Surface

18
1. Rotate the bubble counterclockwise until it
disconnects.
2. Pull the turret to remove it.
3. Rotate the camera counterclockwise until it
disconnects from the skirt.
4. Set aside the bubble, turret, and camera.
1. Mark the mounting surface for screw holes and wire access hole.
• Use the mounting template if you are surface mounting your camera. See
Mounting Template
• Use the flush mount adapter plate as a template if you are flush mounting your
camera.
Figure 2-2 Mounting Template
on page 65
Drill these holes for the
mounting screws.
Cut this hole, then pull the
power, audio, and alarm
wires through it.
Skirt
Camera
Turret
Bubble