Removing Printed Circuit Board (Pcb) - Hitachi FSG Series Service Manual

$
WARNING: TURN OFF all power source switches
5. Disconnect the wiring connector for the fan motor. Remove
the wiring assembly and connector.
6. Remove the casing (1) by pushing the hook part at four (4)
positions towards the inner side.
7. Loosen the screw by a hexagon wrench.
8. Remove the fan motor by sliding it backwards after
removing the fixing plate. Pay attention not to drop it.
2.6.6

REMOVING PRINTED CIRCUIT BOARD (PCB)

1. Remove the intake air grille according to the item, 2.6.1,
"Removing Intake Air Grille".
2. Remove the air filter according to the item, 2.6.2,
"Removing Air Filter".
3. Remove the front cover according to the item, 2.6.4,
"Removing Front Cover".
4. The side cover can be removed by removing three (3)
fixing screws and pulling it downwards
Hook
To Loosen
Fixing screw
Side Panel
Screw
2
SERVICING
37
Connector
Wiring
Assembly
(1)
Casing
Motor
Hexagon
Wrench
Band