Removing Electrical Box Cover; Removing Optional Air Panel - Hitachi FSG Series Service Manual

$
WARNING: TURN OFF all power source switches
2.4.3

REMOVING ELECTRICAL BOX COVER

1. By opening the intake air grille, the electrical box can be
seen. Remove one (1) screw fixing the electrical box cover
and remove the cover.
2.4.4

REMOVING OPTIONAL AIR PANEL

1. Disconnect the wiring connectors after opening the air
intake grille and electrical box cover.
2. Remove screws (P-15DWA(H): 4pcs., P-23DWA(H) and P-
46DWA(H): 6pcs.) fixing the optional air panel onto the
indoor unit.
3. Remove the optional air panel by unhooking the hook of
the suspension bracket.
2. Connector for Auto Swing
Motor (Low Voltage 7pin RED)
Air Panel
CN17 CN13
PCN5
Electrical Control
Box for Indoor Unit
Printed Circuit Board
Long Flocked
Orange
Colored
Only for P-G23,
Mark of Air
Panel
2
SERVICING
23
Indoor Unit
Electrical
Box Cover
*3. Connector for Wireless
receiver Type (Low
Voltage 3pin BLUE)
*: Only for Wireless
Receiver type
1. Connector for Dew
Protection Heater
(High Voltage 2pin RED)
Indoor
Unit
Plates for Fixing Air Panel
Hook
Wire
Long
Screw
Screw
(M6x50)
G46 type)