2
SERVICING
24
$
WARNING: TURN OFF all power source switches
2.4.5
REMOVING FAN MOTOR
1. Remove the intake air grille according to the item, 2.4.2,
"Removing Optional Air Panel".
2. Disconnect the connector for the fan motor.
3. Remove the fan motor mounted on the fixing plate
according to the procedures shown beside.
In Case of 1.0 and 1.5HP
1. Remove the partition plate R and the partition plate L.
2. Remove the screw (B) fixing the motor and loosen the
fixing screw (A)
3. slide the motor toward the (P) direction and remove the
motor
In Case of 2.0~5.0HP
1. Remove the partition plate R and the partition plate L.
2. Remove the screws (B) and (C) fixing the motor and loosen
the fixing screw (A)
3. Slide the motor toward the (P) direction and remove the
motor
4. Remove the casing by pushing four (4) extruded parts at
the lower part of the casing, which consists of two parts.
Partition Plate L
Partition Plate R
Screw (B)
Partition Plate L
Screw (A)
Screw (A)
Partition Plate L
Screw (B)
Extruded Part
Partition
Plate R
A
Electrical Box
Screw (C)
Partition Plate R
Screw (V)
(Only for 3.0~5.0HP)
Casing