Removing Motor For Automatic Louver; Wall Type; Removing Air Filter - Hitachi FSG Series Service Manual

2
SERVICING
28
$
WARNING: TURN OFF all power source switches
2.4.14 REMOVING MOTOR FOR AUTOMATIC
LOUVER
1. Remove the optional air panel according to the item 2.4.4,
"Removing Optional Air Panel".
2. Remove the motor cover at the piping side after removing
two (2) fixing screws.
3. Remove three (3) screws fixing the motor assembly and
remove two (2) stoppers by lifting up the motor assembly in
the arrow direction by hand. The motor assembly can be
removed from the optional air panel by removing the
connectors for wiring.
4. Remove one (1) screw fixing the crank and cut the plastic
tie fixing the motor cord.
5. Remove the motor after removing two fixing screws.
2.5

WALL TYPE

2.5.1

REMOVING AIR FILTER

1. Press two (2) portions (right and left) of the air intake grille
as shown beside.
2. Slowly pull the lower side of the air intake grille toward the
front side.
Motor Cover
Screw
Motor
Assembly
Motor
Plastic Tie
Assembly
Screw
Motor
Crank
Air Intake Grille
Screw
Motor
Assembly
Optional Air
Panel
Connector
Stopper
Motor