I On The Multiscreen Monitor - Panasonic WJ-HD220 Operating Instructions Manual

I On the Multiscreen Monitor

G Selecting the Multiscreen Monitor
1. Press the [SPOT/MULTI] button to turn the LED in the
button off. The multiscreen monitor is ready to be oper-
ated.
2. Follow the descriptions below for each monitoring mode
on the multiscreen monitor.
G Viewing a Single Live
The multiscreen monitor can display a single live spot
image.
Operating procedures are the same as for "On the Spot
Monitor" except for selecting the multiscreen monitor.
G Zooming a Single Live
A single live or playback image on the multiscreen monitor
can be zoomed.
1. Display the desired single live or playback image on
the multiscreen monitor pressing the [ZOOM] button an
appropriate number of times.
MULTISCREEN
SELECT
ZOOM
2. Hold down the [ZOOM] button for 2 seconds to enlarge
the image.
MULTISCREEN
SELECT
ZOOM
3. Rotate the JogDial to move the zoomed area to the right
and left, or press the [D] or [C] button to move the
area up or down.
46
SPOT
MULTI
4. Press the JogDial repeatedly to select an appropriate
enlargement ratio.
Pressing the JogDial : Increases the ratio (x2 → x4)
5. Hold down the [ZOOM] button for 2 seconds to cancel
the zoom mode.
Notes:
• The maximum zooming ratio (x4) will be reduced to x2
when SIF is selected for RESOLUTION in the SYSTEM
SETUP menu.
• To quit enlargement
While displaying a zoomed live image, pressing the
•
[PLAY] button will quit enlargement and start normal
playback.
While displaying a zoomed playback image, pressing
•
the [STOP] button will quit enlargement and display a
live image.
For other cases, hold down the [ZOOM] button for 2
•
seconds.
• The images on the screen may wave vertically when
enlarging live or playback images in the SIF mode. It is
recommended that you select NORMAL for RESOLU-
TION when the display quality is considered much
important.
G
Viewing a Quad Live Sequence
A series of quad and single images is displayed in succes-
sion on the multiscreen monitor. One sequence can be pro-
grammed in the MULTI SEQ SETUP menu with an input
assignment and display duration for each step.
1. Select the multiscreen monitor.
2. Press the [SEQUENCE] button to run the sequence.
The LED in the [SEQUENCE] button lights up.
SEQUENCE
Note: During the sequence, the LEDs of the [CAMERA
SELECT] buttons light up corresponding to the
selected cameras that send images to the monitor.
Multiscreen monitor
1
3. During the sequence, press the [SEQUENCE] button to
pause. The LED in the [SEQUENCE] button blinks.
4. Press the [SEQUENCE] button to restart the sequence.
The LED turns to a steady light.
(4A)
1 2
2
3 4