• Even if preset to 30 or 15 FPS, the actual recording rate
may drop to 7.5 FPS at worst while busy multi task such
as playback, remote-access playback, remote-access
live image, FTP access, multi-split display, or video
motion detection are carried out simultaneously.
The status display will indicate "*→ PLAY" while playing
back the images recorded with a rate different from the
preset.
• The suffix "xxx" following "SP-" is specified in REC
MODE TABLE in the ADDENDUM attached to the man-
ual.
1. Select a recording mode. Audio data will be recorded
when a mode with hyphen A is selected.
Available recording modes: SF, FQ, NQ, EX, SP, SF-
A, FQ-A, NQ-A, EX-A, and SP-A
2. When SP or SP-A is selected, specify a recording rate
(REC RATE).
Available recording rates: From 0.1 to 30 FPS
3. When SP or SP-A is selected, specify a recording quali-
ty (REC QUALITY).
Available recording qualities: SUPER FINE, FINE,
NORMAL, EXTENDED
8 Alarm Recording Mode Setup (ALM REC MODE)
Recording of alarm events arising within the time zone
specified by the program will start with the preset parame-
ters.
Refer to "PROG NO. SETUP" described above for operating
procedures and available parameters, since they are very
similar.
8 Pre-alarm Recording (PRE ALM REC)
Available times (seconds): 0S, 1S, 2S, 3S, 4S, and 5S
8 Post-alarm Recording (POST ALM REC)
Available times (seconds): 5, 10, 20, 30
Available times (minutes): 1, 1.5, 2, 3, 6
Continue: Recording continues until the [RESET] but-
ton is pressed, or the RESET IN signal is supplied to
the rear panel.
Manual: Recording continues while the alarm input is
active, or at least for 10 seconds if the input turns
inactive earlier.
8 Dynamic Recording (DYNAMIC REC)
ALM-MULTI: Alarm activated channels are recorded
with priority over others.
OFF: All channels are recorded with the same priority.