I Communication Setup (Communication Setup); I Serial Port Setup (Serial Port Setup) - Panasonic WJ-HD220 Operating Instructions Manual

I Communication Setup
(COMMUNICATION SETUP)
Click the [SERIAL PORT SETUP] or [NETWORK SETUP]
button. The respective window opens.
I Serial Port Setup
(SERIAL PORT SETUP)
8 Protocol Selection (PROTOCOL SELECT)
PS DATA: Select when the communication chain uses
•
the PS DATA protocol.
•
When selected, the DATA terminal on the rear panel
can be used.
RS-232C: Select when other than PS
When selected, the RS-232C terminal on the rear
panel can be used.
8 Baud Rate (BAUD RATE)
4800: 4 800 bps
9600: 9 600 bps
19200: 19 200 bps
8 Data Bit (DATA BIT)
7: 7 bits
8: 8 bits
8 Parity Check (PARITY CHECK)
8 Stop Bit (STOP BIT)
8 Wait Time (WAIT TIME)
8 Control Unit Addresses
8 System Unit Address (SYSTEM UNIT ADDRESS)
8 Alarm Data (ALARM DATA)
Click the [SET] button when all items have been set proper-
ly.
Click the [CAMERA SYSTEM SETUP] button. The CAMERA
SYSTEM SETUP window opens.
DATA is used.
•
NONE: No parity check
EVEN: Even parity
ODD: Odd parity
1 bit: 1 bit
2 bit: 2 bits
OFF: Retransmission is disabled.
100 MSEC: 100 m seconds
200 MSEC: 200 m seconds
1 SEC: 1 second
(CONTROL UNIT ADDRESS) (only for PS
Assignable address: From 1 to 99, must be unique in
the chain.
(only for PS DATA)
•
Assignable addresses: From 1 to 99, must be unique
in the chain.
OFF: Select this when no system controller is connect-
ed.
0 SEC: Does not pause.
1 SEC: Pauses for 1 second.
5 SEC: Pauses for 5 seconds.
DATA)
•
67