Troubleshooting - Panasonic WJ-HD220 Operating Instructions Manual

TROUBLESHOOTING

Phenomenon
Power is not turned on.
Error message "HDD ERROR" is dis-
played on the monitor.
Error message "CH n LOSS (n=1-8)" is
displayed on the monitor.
Error message "THERMAL ERROR" is
displayed on the monitor.
Administrator password cannot be
recalled.
DISK MENU appears when turning on
the power.
Camera picture is not displayed on the
monitor.
Nine-split display does not function.
Setup menus supplied from the Matrix
Switcher are not recorded.
When accessing via the network:
Remote operations are not accepted
while BUSY indicator is lit.
Slow image refreshment and/or slow
response to operations
Intermittent sound reproduction
No click sound desired.
Cannot search alarm image in the list
84
Cause
Power cord not properly connected
No disk available
Disconnection of camera, camera
cable, or VIDEO IN BNC.
Ventilation blocked, or failure of cooling
fan
HDD status may have changed, or a
malfunction may have occurred.
Lens cap not removed from the cam-
era, some device is not turned on, or
brightness and contrast of the monitor
are improperly adjusted.
QUAD ONLY may be set for MULTI
SELECT MODE.
The WJ-HD220 does not record non-
interlace video.
Front panel buttons on the recorder are
being operated, or more than four PCs
access the recorder.
Network is busy.
Network is busy.
Default setting is ON.
Specified date may be later.
DISK END MODE is set to CONTINUE.
Over 9 999 of alarm events arose.
What to do
Connect the power cord to AC outlet.
Refer to HDD MAINTENANCE in
Appendix to confirm the HDD status.
Consult your dealer when a malfunction
is found.
Connect the respective camera, cable,
or connector properly.
Remove obstacles, or consult your
dealer for servicing.
Reset the recorder to the factory
defaults (page 24) and enter a new
password.
Check the HDD status referring to HDD
MAINTENANCE. Consult your dealer
when a malfunction is confirmed.
Detach the lens cap, turn on the
device, or adjust the monitor.
Set it to ALL.
Wait until the preceding accesses end.
Wait until the preceding accesses end.
Change the setting as follows: Control
Panel → Sound Multimedia → Sound
Tab → Explorer → OFF
Enter a date that is a little older than the
one you wish to search.
Old image data are overwritten and
cannot be searched.
Old records were discarded.