Aligning The Finisher And Printer - Lexmark C920 Service Manual

Aligning the finisher and printer

The following three areas must align properly to prevent paper jams.
1.
The docking plate pins must enter the holes in the finisher.
2.
The space between the printer and finisher must be the same at the top and bottom of the finisher.
3.
The alignment marks on top of the finisher must align with the edges of the cover on the side of the printer.
4.
Roll the finisher toward the printer until the finisher locks to the docking plate pins.
You hear a click when the finisher locks into position.
If the pins did not go into the holes in the finisher, go to
Otherwise, go to
Alignment Marks
Spacing
"Aligning the sides of the finisher" on page
Pin
Hole in Finisher
"Lowering or raising the finisher" on page
3-62.
5056-XXX
3-60.
3-59
Diagnostic aids