950 - Mirror Mismatch
Step
Questions/actions
1
Is 950.xx(xx= 30 or greater) displayed?
2
Replace the operator panel that was just installed with
the original operator panel. Restart the printer. Did this
fix the problem?
3
Replace the RIP card that was just installed with the
original RIP card. Restart the printer. Did this fix the
problem?
952 - NVRAM Chip Failure
952 Service
NVRAM Failure
Step
Questions/actions
1
Make sure the 26-pin RIP printer controller cable is not
broken or damaged.
Is the cable broken or damaged?
2
Is EPROM U7 present on the printer controller board?
954 - NVRAM CRC Failure
Replace the RIP board.
955 - Code CRC
955 Service
Code CRC <loc>
Replace the RIP board.
Yes
No
Go to step 2.
Go to step 3
Problem solved.
Contact your
Install a new
technical support
operator panel.
center.
Do not use the
operator panel
that generated
the 950 error.
Problem solved.
Contact your
Install a new RIP
technical support
card. Do not use
center.
the RIP card that
generated the
950 error.
Yes
No
Replace the
Go to step 2.
cable.
Replace the
Install EPROM
U7.
printer controller
board.
Diagnostic information
5056-XXX
2-19