Alignment marks
Spacing
Aligning the finisher
and printer
Docking plate pin
Hole in finisher
The following three areas must align
properly to prevent paper jams.
1
The docking plate pins must enter
the holes in the finisher.
2
The space between the printer
and finisher must be the same at
the top and bottom of the finisher.
3
The alignment marks on top of the
finisher must align with the edges
of the cover on the side of the
printer.
4
Roll the finisher toward the printer
until the finisher locks to the
docking plate pins.
You hear a click when the finisher
locks into position.
If the pins did not go into the holes
in the finisher, see "Lowering or
raising the finisher" on page 12.
Otherwise, go to "Aligning the
sides of the finisher" on page 13.
11
Setup