Aligning The Finisher With The Printer - Lexmark C920 User Manual

Aligning the finisher with the printer

The following three areas must align properly to prevent paper jams.
Alignment marks
Spacing
1
The docking plate pins must enter the holes in the finisher.
2
The space between the printer and finisher must be the same at the top and bottom of the finisher.
3
The alignment marks on top of the finisher must align with the edges of the cover on the side of the printer.
4
Roll the finisher toward the printer until the finisher locks to the docking plate pins.
You hear a click when the finisher locks into position.
If the pins did not go into the holes in the finisher, see Lowering or raising the finisher. Otherwise, go to
Aligning the sides of the finisher.
Installing and removing options
Docking plate pin
Hole in
finisher
Aligning the optional finisher
37