Table of Contents
Advertisement
5. Short-cut Operations and Specifications
The preset positions below have been programmed with specific functions. These commands can be used to configure
camera control options by assigning the numbers to shortcut keys in a PTZ controller or entering them manually.
Preset #
51
52
53
54
55
Background light compensation*
56
57
58
59
60
61
62
63
79
80
81
82
83
84
85
86
87
88
89
91
94
95
96
101
Pan continuous scanning
5.1. How To Use Shortcut Codes
Enter the desired preset number into the PTZ controller, then call or save to execute the command. Example:
1.
To change "White Balance" mode from "INDOOR" to "OUTDOOR", enter preset number "62" and save the preset.
•
To change the setting back to "INDOOR", enter preset number "62" and call the preset.
•
5.1.1. Preset and Shortcut Notes
•
Shortcut preset points (51-63 and 79-101) may only be used for the functions listed in the shortcuts table.
•
Preset position numbers 1-50, 64-78, and 102-165 may be used to set preset call positions (128 available in total).
Cruise Track (Preset 51): When preset "51" is saved, the camera will auto-scan point by point from preset position "1"
•
to "16" (if they are assigned), pausing for 2 seconds at each position. If no presets are assigned, the camera will not
track.
Line Scanning (Presets 51-53): The camera will scan between two specified points. Set the start and end point by
•
positioning the camera as desired and saving presets "52" and "53".
Line scanning speed may be set by moving the camera for at least three seconds, then calling preset "51".
•
Provided the start and end points have been set, calling preset "52" starts the line scanning from the start point to
•
the end point.
Pan Continuous Scanning (Preset 101): Move the camera at the desired speed for at least 3 seconds, then call preset
•
"101" to begin panning at the speed and in the direction that the camera view was moved.
© 2014 Wirepath Surveillance
Function
Pan-Tilt Control
Camera Power*
Day/Night*
Camera related OSD*
Digital zoom*
Focus*
Iris*
White balance*
Set line-scanning mode
Run pattern
Run vector
Run vector
Picture freeze*
Dynamic preset point
Dome reset
Main menu
Set the auto flip
Call Preset
Record line-scanning speed
Start line-scanning
-
On
On
Auto
Camera menu On\Off
On
Auto
Auto
Auto
Indoor
ATW
Long distance
Run pattern 1
Run pattern 2
Run pattern 3
Run vector scan 1
Run vector scan 2
Run vector scan 3
Run vector scan 4
Run vector scan 5
Run vector scan 6
On
Call dynamic preset point
Call main menu
On
On
WPS-500/750-PTZ-A Installation Manual
Save Preset
Run cruise track
Set line-scanning starting point
Set line-scanning ending point
Off
Off
Color
Camera function OSD On\Off
Off
Manual
Manual
Manual
Outdoor
One-push WB
Short distance
Off
Reset dome
Off
29
Advertisement
Table of Contents
