Stopping; Trim Angle - TOHATSU MFS 4C Owner's Manual

ENOM00419-0

6. Stopping

1
1. Hock
2. Stop switch lock
3. Stop switch
1. Turn the throttle grip to the slow posi-
tion.
2. Put the shift lever in the Neutral posi-
tion.
Run the engine for 2-3 minutes at
idling speed if it has been running at full
speed.
3. Push the stop switch to stop the
engine or release the stop switch lock.
ENOW00042-0
WARNING
 Do not shift into Reverse during planing,
or control will be lost leading to serious
personal injury, boat may swamp, and/or
hull may be damaged.
 Do not shift into Reverse during cruis-
ing, or control may be lost, falling down
or causing passenger(s) to be thrown
overboard. Leading to serious personal
injury, and steering system and/or shift-
ing mechanism may be damaged.
ENON00402-0
Notes
 After stopping the engine, close the air
 Disconnect the fuel connector of the
2
ENOM00050-0

7. Trim angle

The trim angle of the outboard motor can
3
be adjusted to suit the transom angle of
ENOF00210-0 ENOF00439-0
the hull, and load conditions. Choose an
appropriate trim angle that will allow the
anti-ventilation plate to run parallel to the
water surface during operation.
ENOM00420-0
Proper trim angle
The position of the thrust rod (or preset
knob) is correct if the hull is horizontal dur-
ing operation.
1. Perpendicular to the water surface
ENOM00421-0
Improper trim angle
Set the thrust rod (or preset knob) lower if
the bow of the boat rises above horizontal.
ENGINE OPERATION
vent screw on the tank cap.
engine or the fuel tank.
90˚
33
1
ENOF00051-0