TOHATSU MFS 4C Owner's Manual page 50

50
INSPECTION AND MAINTENANCE
1
2
3
4
1. Carburetor
2. Fuel filter
3. Fuel pump
4. Fuel pipe
ENOM00434-0
Fuel filter (for fuel tank)
Loosen the fuel pickup elbow shown at
left, remove it and clean the fuel filter.
1
1. Filter
2. Fuel pick up elbow
ENOM00097-0
Fuel tank
Water or dirt in the fuel tank will cause
engine performance problems.
Check and clean the tank at specified
times or after the outboard motor has
been stored for a long period of time (over
three months).
ENOM00098-0
Replacing gear oil
ENOW00094-0
 Be sure that outboard motor is secured
to transom or service stand, or acciden-
tal drop or fall of outboard motor could
lead to severe personal injury.
 Be sure to lock outboard motor if it is
ENOF00455-0
tilted up, or accidental fall of outboard
motor could lead to severe personal
injury.
 Do not go under outboard motor tilted
up and locked, or accidental fall of out-
board motor could lead to severe per-
sonal injury.
1. Remove the oil plugs (upper and
lower), and completely drain the gear
oil into a pan.
2
ENOF00456-0
1. Oil plug hole (Upper)
2. Oil plug (Lower)
2. Insert the oil tube nozzle into the lower
oil plug hole, and fill with gear oil by
squeezing the oil tube until oil flows out
of the upper plug hole.
ENOW00095-0
Do not reuse oil plug gasket. Always use
new gasket and tighten oil plug properly to
prevent entry of water into lower unit.
WARNING
1
2
ENOF00463-0
CAUTION