Table of Contents
Advertisement
External Control
Interface Settings
Serial Interface Settings
Before connecting an editor or AUX bus remote controller,
you must set up the serial interface by making
communication settings.
To make communication settings, use the Serial sub menu
of the Setup menu. The Serial sub menu has the following
sub menus.
Sub menu
Operation
Protocol
Set the communication protocol
Baudrate
Set the baud rate
Parity
Set the parity bit
Chapter
To show the sub menus
EDITOR button
BKDF-901
EDITOR button
BKDF-902
In the External Connections and Power block, press the
EDITOR button twice in quick succession.
The most recently used sub menu appears in the display
panel.
To switch between sub menus, press the h and H
buttons in the numeric keypad.
Note
Always make the communication settings in these sub
menus before connecting a serial communications device.
7
161
Serial Interface Settings
Advertisement
Table of Contents
