Adding Trail Effects, And Changing The Color Type - Sony DFS-900M Operating Instructions Manual

Softness sub menu parameters
Adjust the following parameters to adjust the softness of
the inner and outer sides of the border.
Operation Knob Parameter
Adjust the F1 InS (Inner
softness of the Softness)
inner side of the
border.
Adjust the F2 OutS (Outer
softness of the Softness)
outer side of the
border.
Bevel Color sub menu parameters
Beveled edges make a border appear three dimensional.
Adjust the following parameters to select whether to add
beveled edges to an image, and to adjust the color of the
beveled edges, if added.
Note
It is not possible to adjust the widths of left, right, top, and
bottom beveled edges independently.
Beveled edge
Beveled edge example
For information about how to adjust beveled edge widths,
see "Inner Width sub menu parameters" (page 138) and
"Outer Width sub menu parameters" (page 138).
Operation Knob Parameter
Select whether F1 Bvl (Beveled
to add beveled Enable)
edges to an
image.
Adjust the F2 Lum (Luminance) 0.0 to 108.6
luminance of the
beveled edges.
Adjust the F3 Sat (Saturation)
saturation (color
density) of the
beveled edges.
Adjust the hue of F4 Hue
the beveled
edges.
Border HL (Highlight Setup) sub menu
parameters
Adjust the following parameters to specify the direction
and brightness of the light source that illuminates beveled
Settings
edges.
0 to15
0 to15
Lowlight
part
Operation
Set the direction of
the light source.
(Specify as a
position
corresponding to a
number on the face
of an analog clock.)
Example: 3
corresponds to the
direction from 3
o'clock.
Set the mixture ratio
of the highlight
(lighter) part and the
border color.
Set the mixture ratio
of the lowlight
(darker) part and
the border color.
Adding Trail Effects, and Changing
the Color Type
Settings
You can adjust the parameters of the Sub Effects sub
On: Add
menus to add trail effects to images. You can also change
Off: Do not
the image color type (chroma control).
add
Trail effect: Adds trail-like afterimages.
Chroma control: Allows you to change the color type of
images to sepia, black and white, or negative.
0.0 to 100
0.0 to 359.5
Beveled edge
Highlight
part
Beveled edge example
Knob Parameter Settings
F1 Dir (Hilight 0 to 11
Direction)
F2 HL (Hilight 0 to 100.0
Opacity)
F3 LL (Lowlight 0 to 100.0
Opacity)
Customizing DME Effects
Light
source
direction
139