Editing Sequences - Sony DFS-900M Operating Instructions Manual

LOOP button
Bx (play/stop) button
X (pause/restart) button
X (pause/restart) button: Pauses play when pressed
during play, and restarts play from the paused position
when pressed again.
Bx (play/stop) button: Starts play when pressed, and
stops play when pressed again.
LOOP button: Selects loops play. If you want loop play,
press this button to light it before starting play.
DIR button: Reverses the play direction.

Editing Sequences

After recalling a sequence, you can edit it by changing
parameters and by adding or deleting keyframes.
To change parameters
Use the Seq Edit sub menu to change parameters.
To display the Seq Edit sub menu
Press the SEQ button in the numeric keypad.
The most recently used sub menu appears in the display
panel.
Press the j and J buttons in the numeric keypad until
the Seq Edit sub menu appears.
j button
h button
DIR button
J button
STORE button
H button
The Seq Edit sub menu displays the total number of
keyframes (Total) registered in the currently recalled
sequence, and the number of the current keyframe (Cur).
The current keyframe is the keyframe at the current display
position. You can press the h and H buttons to move
the current keyframe.
The following parameters can be changed.
Knob Parameter Description
F1 Sequence execution
a)
Play
(play) time
F2 Brk b) Pause at each
keyframe
F3 a) Interval
Ival
F4 Mode Interpolation mode
a) The interval is a relative value with respect to the execution time. It
changes whenever the execution time changes.
b) Setting this to On results in a pause between individual keyframes, which
is convenient if you want to add or delete keyframes.
When you have finished changing parameters, press the
STORE button to save the changes.
Note
Unless you save them, changes to parameters are lost when
the switcher is powered off. Always save the sequence
whenever you change sequence parameters.
For information about how to save sequences, see
"Creating Sequences" (page 156).
To add keyframes
You can add new keyframes at any point in a sequence. To
add a keyframe, recall a sequence and then proceed as
follows.
Total number of keyframes
Current keyframe
Settings
1 to 3200
On, Off
1 to 999
Point, Line, Curve
Sequence Operations
159