Sony DFS-900M Operating Instructions Manual page 41

To install I/O expansion boards
Output expansion board channel numbers
Whether board can be
installed
Output BKDF-960
number 4 SDI Output
display after Board
installation
BKDF-961
2 SD Video
Output Board
BKDF-962
2 DVI Output
Board
a) AUX05 and AUX06 are invalid.
b) AUX09 and AUX10 are invalid.
Use the following procedure to install expansion boards. (The example figures
show the lower expansion board tray, but the procedure is the same for the upper
tray.)
1
Remove the four screws (+B 3×6) securing the board tray stabilizers, and
remove the stabilizers.
2
As shown in the figure below, push the levers on each end of the expansion
board installation tray to open them, and then pull the tray out.
Installation position on expansion board
installation tray
Lower tray Upper tray
Left Center Right Left
No No Yes No
– – AUX03 –
to
AUX06
– – AUX03 –
to
a)
AUX04
Installing Optional Expansion Boards
Center Right
No Yes
– AUX07
to
AUX10
– AUX07
to
b)
AUX08
41