Sony DFS-900M Operating Instructions Manual page 85

Specifying the signal type of DVI input signals
Setting Name of
of step 5 BKDF-911
connector
Y/CB/CR COMP/Y
B-Y
R-Y
COMP
a) Connector is disabled
6
If you selected Y/CB/CR in step 5, rotate the F4 knob to select the level of
the component input signals.
Betacam: Betacam level
SMPTE: SMPTE level
Note
Settings of step 6 can be available only when the switcher's video format
(see page 71) is set to 525/59, 720/59, or 1080/59.
When you are using the optional BKDF-912 2 DVI Input Board, specify the
picture size and aspect ratio conversion modes for the DVI signals that will be
input to the board.
For more information about the BKDF-912, see page 31. For information about
how to install it, see page 39.
Note
Depending on the video format setting of this switcher (page 71), select the DVI
input signal resolution from the values in the following table. If you specify a
resolution other than the values shown in the table, images may be unable to be
reproduced normally.
Video format setting
525/59 or 625/50
720/50 or 720/59
1080/50 or 1080/59
Input signal BKDF-911 installation position
and channel number
Lower tray
Left Center
Luminance IN09 IN13
(Y) signal
Color
difference
(B-Y) signal
Color
difference
(R-Y) signal
Composite IN10 IN14
signal
DVI input signal resolution
VGA (640 × 480)
SVGA (800 × 600)
XGA (1024 × 768)
XGA (1024 × 768)
SXGA (1280 × 1024)
WXGA (1280 × 768)
XGA (1024 × 768)
SXGA (1280 × 1024)
WXGA (1280 × 768)
UXGA (1600 × 1200)
WSXGA (1680 × 1050)
WUXGA (1920 × 1200)
Basic Switcher Settings
Upper tray
Left Center
IN17 IN21
IN18 IN22
85