Oled Power Up (Oled Is In Off Condition) - WisyCom MTP41 User Manual

Powering up
Move the wireless power switch (see Fig. 1) in "I" position to activate wireless transmission:
the front green LED ❷
Setup control
Open transmitter Body to access the "display and controls" area (Fig. 3):
A
C
B

OLED Power UP (OLED IS IN OFF CONDITION)

Pushing down selector (click), oled turns on. A first menu with Serial Number and brand logo is
displayed, then <status> menu enters automatically.
Turn on the transmitter pushing and holding selector (click) > 2 sec, Serial Number menu is
displayed till (-/+) is selected.
OLED Power DOWN (OLED IS IN ON CONDITION)
Pushing and holding selector (click) > 2 sec, display is turned off.
Display turns off automatically after 15 sec, unless in <IRDA> menu or in <AUDIO> menu (with
audio level < 5% from nominal).
lights up (blinking when battery is low!)
D
MTP41 User Manual
A. Graphics Display (OLED)
B. Channel selection buttons (ch)
C. MIC gain setup buttons (gain)
D. 3 position selector (up / down / click)
Fig. 3
Rev.01
CLICK
+ -
6