zortrax M200 Manual page 21

SUPPORT & MAINTENANCE
1
4
5
2
6
3
LP. MIEJSCE CZYNNOŚCI
1 Main Cleaning the machine and its environment, especially bottom plate of the
printer
2 Head Check if the head is not clogged with the filament remains
Remove the filament remains
3 Build plate Cleaning perforated platform
Checking perforated platform deformation
Levelling the platform
Cleaning the bottom of perforated platform
Perforated platform straightening
4 X, Y axes Checking if axes are not contaminated with filament remains
Remove filament remains from XY axes
Checking the drive belt tension on XY axis
Checking the drive belt tension between XY motors and the axes
Checking if screws blocking pulleys on XY axis and pulleys on motor axis are
tighten
Checking if the extruder moves freely when printer is off
Lubricating XY axes
5 Extruder Checking if screws blocking heating block are tighten
Removing the filament remains and solids from the extruder
Checking if the fan is working
6 Lifting mechanism Checking if vertical line shafts and propulsion screw are not contaminated
with filament remains
Checking if ball screw and ball nut are tighten
Propulsion screw lubricating
Linear shafts lubricating
CZĘSTOTLIWOŚĆ
Before each printing
Before each printing
Before each printing
Before each printing
Before each printing
Each 50 working hours
Each 100 working hours
Each 100 working hours or
if necessary
Before each printing
Before each printing
Each 100 working hours
Each 100 working hours
Each 100 working hours
Each 100 working hours
Each 250 working hours
Each 100 working hours
Each 100 working hours
Each 250 working hours
Before each printing
Each 100 working hours
Each 100 working hours
Each 250 working hours
21