Table Of Content Unplugging the Power Cable Unscrewing the Endstop Endstop Removal Plugging the Cables into the Endstop Endstop Assembly Plugging the Power Cable page 2 / 9...
Page 3
The endstop is an extruder movement control tool which is responsible for sensing the extruder’s position. Each M Series and M Series Plus printer is equipped with two endstops – one located at the end of the X axis and the other at the end of the Y axis, both are located in the front corners of the housing.
Plugging the Cables into the Endstop Plug the cables into the new endstop. Remember to keep a proper connection system. One cable must be connected to the pin no. 1 and the other cable to the pin no. 3. The pins are marked on the endstop. page 7 / 9...