Related Manuals for zortrax M200
Summary of Contents for zortrax M200
- Page 1 Power Switch Replacement SOURCE: https://support.zortrax.com/power-switch-replacement/ page 1 / 19...
-
Page 2: Table Of Contents
Table Of Content Unplugging the Power Cable Changing the Printer's Position Unscrewing the Bottom Plate, part 1 Turning the Printer Unscrewing the Bottom Plate, part 2 Separating the Bottom Plate Unscrewing the Power Switch Power Switch Removal Power Switch Installation Securing the Power Switch Bottom Plate Installation Securing the Bottom Plate, part 1... - Page 3 Follow the instructions provided in this manual to see the correct replacement procedure. The following manual shows the M200 repair work. For the M300, M200 Plus and M300 Plus, these procedures are the same. page 3 / 19...
-
Page 4: Unplugging The Power Cable
Unplugging the Power Cable Turn off the machine and unplug the power cable. Wait a few minutes for all the capacitors to discharge. page 4 / 19... -
Page 5: Changing The Printer's Position
Changing the Printer's Position Grab the printer’s housing and change the printer’s position so that you can easily access the bottom plate. page 5 / 19... -
Page 6: Unscrewing The Bottom Plate, Part 1
Unscrewing the Bottom Plate, part 1 Unscrew the screws that secure the bottom plate on one side of the housing. Use a 2.5mm Allen key. page 6 / 19... -
Page 7: Turning The Printer
Turning the Printer Turn the printer over. page 7 / 19... -
Page 8: Unscrewing The Bottom Plate, Part 2
Unscrewing the Bottom Plate, part 2 Unscrew the screws that secure the bottom plate on the other side of the housing. Use the same key. page 8 / 19... -
Page 9: Separating The Bottom Plate
Separating the Bottom Plate Separate the bottom plate from the printer and unplug the bottom fan cable from the motherboard. page 9 / 19... -
Page 10: Unscrewing The Power Switch
Unscrewing the Power Switch Unscrew the two screws that secure the power switch. Use a 2mm Allen key. page 10 / 19... -
Page 11: Power Switch Removal
Power Switch Removal Separate the power switch from the housing, remove the insulation from the cables and unplug all the cables. page 11 / 19... -
Page 12: Power Switch Installation
Power Switch Installation Install the new power switch in the housing, plug all the cables in and put the insulation back on the cables. page 12 / 19... -
Page 13: Securing The Power Switch
Securing the Power Switch Secure the power switch with the two screws using a 2mm Allen key. page 13 / 19... -
Page 14: Bottom Plate Installation
Bottom Plate Installation Plug the bottom fan cable into the motherboard and install the bottom plate. page 14 / 19... -
Page 15: Securing The Bottom Plate, Part 1
Securing the Bottom Plate, part 1 Secure the bottom plate with the screws on one side of the housing. Use a 2.5mm Allen key. page 15 / 19... -
Page 16: Turning The Printer
Turning the Printer Turn the printer over. page 16 / 19... -
Page 17: Securing The Bottom Plate, Part 2
Securing the Bottom Plate, part 2 Secure the bottom plate with the screws on the other side of the housing. Use the same key. page 17 / 19... -
Page 18: Changing The Printer's Position
Changing the Printer's Position Grab the printer’s housing and set the printer upright. page 18 / 19... -
Page 19: Plugging The Power Cable
Plugging the Power Cable Plug the power cable in. page 19 / 19...