Related Manuals for zortrax M200
Summary of Contents for zortrax M200
- Page 1 Display Panel Replacement SOURCE: https://support.zortrax.com/m-series-display-panel-replacement/ page 1 / 13...
-
Page 2: Table Of Contents
Table Of Content Unplugging the Power Cable SD Card Removal Unscrewing the Display Panel Display Panel Back Cover Removal Display Panel Removal Connecting the Display Panel Display Panel Installation Securing the Display Panel Inserting the SD Card Plugging the Power Cable page 2 / 13... - Page 3 (it rotates with resistance or becomes too loose), the display panel needs to be replaced. This manual shows the correct replacement procedure. The following manual shows the M200 repair work. For the M300, these procedures are the same. page 3 / 13...
-
Page 4: Unplugging The Power Cable
Unplugging the Power Cable Turn off the printer and unplug the power cable. page 4 / 13... -
Page 5: Sd Card Removal
SD Card Removal Remove the SD card from the slot. page 5 / 13... -
Page 6: Unscrewing The Display Panel
Unscrewing the Display Panel Unscrew the four screws that secure the panel to the front frame of the printer page 6 / 13... -
Page 7: Display Panel Back Cover Removal
Display Panel Back Cover Removal Carefully separate the back cover from the front frame. page 7 / 13... -
Page 8: Display Panel Removal
Display Panel Removal Unplug the display connector and remove the display panel. page 8 / 13... -
Page 9: Connecting The Display Panel
Connecting the Display Panel Connect the new display panel. page 9 / 13... -
Page 10: Display Panel Installation
Display Panel Installation Install the display panel with the back cover. page 10 / 13... -
Page 11: Securing The Display Panel
Securing the Display Panel Secure the panel with the four screws. page 11 / 13... -
Page 12: Inserting The Sd Card
Inserting the SD Card Insert the SD card into the slot. page 12 / 13... -
Page 13: Plugging The Power Cable
Plugging the Power Cable Plug the power cable in. page 13 / 13...