Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for zortrax M200
Summary of Contents for zortrax M200
- Page 1 Packing SOURCE: https://support.zortrax.com/m200-packing/...
-
Page 2: Table Of Contents
Table Of Content Unplugging the Power Cable Unplugging the Extruder Cable Removing the Platform Lifting the Heatbed Mount Placing the Starter Kit Box Placing the Accesories Foam Setting the Extruder in the Right Position Placing the Fillers Wrapping the Printer Placing the Bottom Cushioning Putting the Printer in the Box Placing the Top Cushioning... -
Page 3: Unplugging The Power Cable
Unplugging the Power Cable Turn the printer off, unplug the power cable and wait until the printer cools down. -
Page 4: Unplugging The Extruder Cable
Unplugging the Extruder Cable Unplug the extruder cable. -
Page 5: Removing The Platform
Removing the Platform Unplug the heatbed cable. Both big and small connectors need to be unplugged. Remove the platform from the printer. -
Page 6: Lifting The Heatbed Mount
Lifting the Heatbed Mount Lift the heatbed mount. -
Page 7: Placing The Starter Kit Box
Placing the Starter Kit Box Put the platform into the Starter Kit box and place the box on the bottom of the printer. -
Page 8: Placing The Accesories Foam
Placing the Accesories Foam Place the printer accessories in the accessories foam. Put the foam with the accessories on the Starter Kit box inside the printer, then lower the heatbed mount so that the box and the foam are tightly secured. -
Page 9: Setting The Extruder In The Right Position
Setting the Extruder in the Right Position Move the extruder manually to the back right corner of the printer. Secure the extruder with the shipping clips. -
Page 10: Placing The Fillers
Placing the Fillers Place the fillers on the foam. -
Page 11: Wrapping The Printer
Wrapping the Printer Wrap the printer in foil. -
Page 12: Placing The Bottom Cushioning
Placing the Bottom Cushioning Place the cushioning at the bottom of the box. -
Page 13: Putting The Printer In The Box
Putting the Printer in the Box Place the printer on the bottom cushioning inside the box. Be careful not to damage the knob next to the display. -
Page 14: Placing The Top Cushioning
Placing the Top Cushioning Place the top cushioning on the printer so that the cushioning fits the extruder. -
Page 15: Packing The Printer
Packing the Printer Pack the printer using the provided box. -
Page 16: Taping The Box
Taping the Box Tape the box.
Need help?
Do you have a question about the M200 and is the answer not in the manual?
Questions and answers