Table of Contents
Advertisement
FatTwin F627R3-RTB+/R72B+ User's Manual
Installing a Front Low-Profi le Expansion Card
Each motherboard node supports one low-profi le expansion card.
Installing a Front Expansion Card into a Node
1. Power down the system and remove the power cord from the rear of the
power supply as described in Section 6-3. Remove the node from the chassis
as described in Section 6-4 and place the node on a fl at, stable surface.
Remove the cover from the node as described in Section 6-6.
2. Remove the mounting screw which secures the PCIE slot cover in the PCIE
slot and set this aside for later use.
Figure 6-17: Removing the Screw Securing the PCIE Slot Cover
3. Remove the PCIE slot cover by sliding it upward and out of the PCIE slot.
4. Remove the screws securing the riser card bracket to the chassis and set
them aside for later use.
Figure 6-18: Removing the Screw Securing the PCIE Slot Cover
6-20
1
2
Advertisement
Table of Contents
