Table of Contents
Advertisement
FatTwin F627R3-RTB+/R72B+ User's Manual
6-9
Adapter Card Replacement
Each of the motherboard nodes for the F627R3-R72B+ server includes an adapter
card, which connects it to the chassis. In the unlikely event of a failure of the adapter
card, replacement is simple and requires only a Phillips head screwdriver.
Changing the Adapter Card
1. Power down the system and remove the power cord from the rear of the
power supply as described in Section 6-3. Remove the node from the chassis
as described in Section 6-4 and place the node on a fl at, stable surface.
Remove the cover from the node as described in Section 6-6.
2. Remove the two screws securing the adapter card to the wall of the node.
3. Disconnect all cables.
4. Carefully lift the adapter card up and out of the node. Set the screws aside
for later use.
5. Install the replacement adapter card into the same position on the wall of the
motherboard node, aligning the mounting holes of the board with those in the
node.
6. Secure the board with the two screws previously set aside. Do not exceed
eight pound of torque when tightening the power adapter board.
7. Reconnect all cables.
8. Return the motherboard node to the chassis.
(Your node and backplane may differ from the one shown in this illustration)
Figure 6-12: Installing the Adapter Card
6-14
Advertisement
Table of Contents
