Installing A Rear Micro Lp Expansion Card - Supero FatTwin F627R3-R72B+ User Manual

Installing a Rear Micro LP Expansion Card

Installing the Micro LP Expansion Card into the Node
1. Power down the system and remove the power cord from the rear of the
power supply as described in Section 6-3. Remove the node from the chassis
as described in Section 6-4 and place the node on a fl at, stable surface.
Remove the cover from the node as described in Section 6-6.
2. Remove the mounting screw securing the Micro LP slot cover and set it aside
for later use.
3. Simultaneously place the micro expansion card into the Micro LP slot of the
node and plug the card into the slot on the motherboard.
4. Secure the Micro LP expansion card to the node with two mounting screws.
Figure 6-16: Installing a Rear Micro LP Expansion Card
(Your node and motherboard may differ from the one shown in this illustration)
Micro Expansion Card
Mounting Screws
Chapter 6: Advanced Chassis Setup
6-19
Micro Low-
Profi le PCI Slot