Connecting The Control Panel - Supero FatTwin F627R3-R72B+ User Manual

Back Panel I/O Port Locations and Defi nitions
1.
2.
3.
4.
5.
6.

Connecting the Control Panel

JF1 contains header pins for various front control panel connectors. See Figure 5-1
for the pin locations of the various front control panel buttons and LED indicators.
Even and odd numbered pins are on opposite sides of each header.
All JF1 wires have been bundled into single keyed ribbon cable to simplify their
connection. The red wire in the ribbon cable plugs into pin 1 of JF1. Connect the
other end of the cable to the Control Panel printed circuit board, located just behind
the system status LEDs in the chassis.
See the Connector Defi nitions section in this chapter for details and pin descriptions
of JF1.
Figure 5-2. Front Control Panel Header Pins (JF1)
SMBUS Alert for Hot Swap on
BPN-ADD-F418 PWR Adp. Card
PWR Good of BPN-ADP-F418
PWR Adaptor Card
USB Port 1
USB Port 2
VGA Port
Gigabit LAN 1
Gigabit LAN 2
IPMI LAN
20
PMBUS DAT
X
PS Failure
Red LED (Failure)
Signal
PS_ON_N to PS
Fan Speed Signal 2
LAN LED Signal
Ground
2
5-3
Chapter 5: Advanced Motherboard Setup
19
PMBUS CLK
X
SMBUS DAT for Hot Swap on
BPN-ADD-F418 PWR Adp. Card
SMBUS CLK for Hot Swap on
BPN-ADD-F418 PWR Adp. Card
UID LED Signal
Front Panel PWR LED
PWM for Fan to Backplane
Fan Speed Signal 1
UID Button
Power Button
1