Media Counter - ENCAD CADJET 3D User Manual

Á
To set end of media feeder stop
Press Feed Media Menu/End of Media.
1
Choose Feeder Stop.
2
Press OK.
3

Media counter

Media Counter gives you a means of estimating the amount of media left on a roll.
When a new roll of media, or a used roll where the remaining length is known, is in-
stalled on the printer, you can enter the length of the roll into the printer's front panel
display. As the printer prints, this amount is decremented. You can view the estimated
amount of media remaining on the printer's front panel display. When you are ready to
remove the roll, you can print the estimated amount of media remaining on the roll.
When you reload this media, you can use this figure to enter into the printer's front panel
display. The media counter can be reset to 0 to avoid confusion if the media counter is
not being used. The media counter will not decrement below 0. The current value of the
media counter is maintained across power cycles. The current value is not stored as a
user parameter.
Á
To enter a media length value
Press Feed Media Menu/Media Counter.
1
2 Set the media length.
Press OK.
3
Á
To display the current value
Press Feed Media Menu/Display Counter.
1
2 View the current value.
Press EXIT.
3
Á
To print the current value
Press Feed Media Menu/Display Counter.
1
Press Print Counter.
2
Press EXIT.
3
®
CADJET 3D User Guide
Printer Options 2-5