Table of Contents
Advertisement
Enable Auto Cutter: With Control set to Printer, the printer will ignore EC commands in
the plot file and will not automatically cut after each plot. From the printer's front panel,
you can enable automatic cutting or initiate a command for a single cut.
Do not override software control when sending merged raster/vector data to the printer.
Á
To set control
Press Setup Menu/HP-GL/2 menu/Control.
1
Choose either Software or Printer.
2
Press OK.
3
Rotation
The printer automatically prints an image with the long side on the paper axis. To better
fit images and save media, you can use the Rotation option to turn vector files counter-
clockwise 90 degrees at a time. If the rotation specified won't fit on the media or contains
raster images, it will not be rotated. When the Rotate value is set to AUTO, the algorithm
will automatically rotate the plot if it determines that the rotation will save media (regard-
less of whether Nesting is enabled). If Rotate is set to 0, the plot will not be rotated.
The Control function does not override the RO command in the plot file.
Note: Rotation is supported for HP-GL/2 files only. It is not supported for RTL files.
Á
To rotate the image
Press Setup Menu/HP-GL/2 menu/Rotation.
1
2
Choose the rotation angle (0, 90, 180, 270, auto).
Press OK.
3
Reprints
You can print up to 99 copies of a specific vector file. When Reprint is set to 0, only one
image is printed.
®
CADJET
3D User Guide
HP-GL/2
4-3
Advertisement
Table of Contents
