To stop barcode scanning by sending the stop command in the terminal (such as PC) or reading the ―Stop Simulating
Trigger‖, and require a 2-Digit character passback(such as 0A,0X,etc.,)
【Begin Simulating Trigger】
【Stop Simulating Trigger】
If the reading fails, the scanner will send a symbol to describe that the reading is not successful. Customer can set this
symbol.
Security Level Setup
This value indicates the number of times to decode before correct reading of the confirmation code, the higher value
indicated the wrong decoded rate is lower and slower decode speed, on the contrary, faster the decode speed.
【Set Security Level to 1】
【Set Security Level to 2】
24
【Set the Character to Describe Unsuccessful Reading】
【Commnad Triggered Scanning】
【Set Security Level to 3】
【Set Security Level to 4】
【Start Setup】
【Exit Setup】