Programming Code
Reading Mode
»
Hand-held Mode: Pull and keep holding the trigger line
to read. Complete one reading or release the trigger to terminate
reading status.
»
Auto Mode: The ambient luminance change in front of the
engine automatically initiates reading. After completion of reading,
the engine goes to idle. Both luminance change and the Trigger can
initiate reading when idle.
»
Continuous Mode: Pull the Trigger line low to start reading.
The engine will keep reading. To stop, pull trigger line low again.
Hand-held Mode
(Factory Default)
Auto Mode
Code Programming ON
Code Programming OFF
Continuous Mode
E-13