Using External Devices; Accessibility Features - Cisco 7906G User Manual

Using External Devices

The following information applies when you use external devices with the Cisco Unified IP Phone:
Cisco recommends the use of good quality external devices (headsets) that are shielded against
unwanted radio frequency (RF) and audio frequency (AF) signals.
Depending on the quality of these devices and their proximity to other devices such as mobile phones
or two-way radios, some audio noise may still occur. In these cases, Cisco recommends that you take
one or more of the following actions:
• Move the external device away from the source of the RF or AF signals.
• Route the external device cables away from the source of the RF or AF signals.
• Use shielded cables for the external device, or use cables with a better shield and connector.
• Shorten the length of the external device cable.
• Apply ferrites or other such devices on the cables for the external device.
Cisco cannot guarantee the performance of the system because Cisco has no control over the quality
of external devices, cables, and connectors. The system will perform adequately when suitable devices
are attached using good quality cables and connectors.
Caution In European Union countries, use only headsets that are fully compliant with the EMC
Directive [89/336/EC].

Accessibility Features

A list of accessibility features is available upon request.
Cisco Unified IP Phone 7906G and 7911G for Cisco Unified CallManager 5.0 (SCCP)
Getting Started
11