Using A Handset, Headset, And Speaker; Using The Group Listen Feature - Cisco 7906G User Manual

Using a Handset, Headset, and Speaker

The Cisco Unified IP Phone 7906G and 7911G provide a speaker for hands-free listening. You can use
the speaker only to listen to a call. To talk on a call, you must use the handset.
You can use the speaker in one of two ways, depending on how your system administrator enables the
phone. Your phone may be enabled for one of the following features, but not both at the same time:
• Group Listen
• Monitor (default)

Using the Group Listen Feature

The following table shows how you can use the Group Listen feature.
If you want to...
Use the handset
Talk using the handset and listen
on the speaker at the same time
(Group Listen)
Turn off Group Listen and use the
handset
Hang up after using Group Listen Press EndCall or hang up.
Adjust the volume level for a call
Note If your system administrator has disabled the speaker on your phone, the GListen, GLOff,
Monitor, and MonOff softkeys will not be available to you. You must lift the handset to place
and monitor calls.
Cisco Unified IP Phone 7906G and 7911G for Cisco Unified CallManager 5.0 (SCCP)
Then...
Lift it to go off-hook; replace it to go on-hook.
Press GListen.
Note Group Listen must be enabled by your system administrator
for the GListen softkey to display.
Press GLOff.
Note When using Group Listen, adjusting the volume only
changes the volume for the speaker and not the handset.
Press the up or down Volume button during a call or after
invoking a dial tone.
Press Save to preserve the volume level for future calls.
Using a Handset, Headset, and Speaker
37