Building Your Own Power Cable; Attaching The Power Cable To The Connector; Attaching The Camera Lens; Figure 13. Serial Communications Cable Rs-232B-12 (Jai Inc. Part Number: 310 132 19) .33 Figure 14. 12P-02S Interface Cable (Optional) - JAI Pulnix TS-2030EN Series User Manual

12P-02S Interface Cable (optional)
FIGURE 14.
12P-02S Interface Cable
Pin# Lead Color
1
2 Yellow
3 Red coax shield
4 Red coax
5 Orange coax shield
6 Orange coax
Note: Make sure that the unused leads are not touching and that there is no possibility that
exposed wires could cause the leads to short.
5.3.3

Building Your Own Power Cable

Refer to the 12-pin connector pin-out in Figure 14 on page 35. Connect the Ground lead to pin #1, and
the +12V DC lead to pin #2 of the 12-pin connector. Power must be DC-regulated, and of sufficient
current to properly power the camera.
5.3.4

Attaching the Power Cable to the Connector

The 12-pin connector is keyed and will only fit in one orientation. Follow these directions to properly
attach the power cable to the camera connector:
Rotate the connector while applying slight pressure until the keyways line up.
1.
Press the connector into place until firmly seated.
2.
Plug the power cord into the 100V AC socket. This will power the camera up.
3.

5.4 Attaching the Camera Lens

The TS-2030EN/TS-2076EN camera accepts 1" or larger format size C-mount lenses. To attach the C-
mount lens to the camera, carefully engage the threads and rotate the lens clockwise until it firmly seats
on the mounting ring. Do not force the lens if it does not seat properly. Please note that some lenses
with extremely long flangebacks may exceed the mounting depth of the camera.
TS-2030EN/TS-2076EN Series Progressive Scan Cameras
Function
Gray GND
+12V DC
AGND
Video Out
GND
VINIT IN
Pin# Lead Color
7 Black coax
8 White coax shield
9 White coax
10 Brown
11 Blue
12 Black coax shield
Connectors and Cables
Page 35
Function
Reserved
Reserved
Reserved
RxD
Reserved
TXD