JAI Pulnix TS-2030EN Series User Manual page 40

Page 28
TS-2030EN/TS-2076EN Series Progressive Scan Cameras
Enter the command "ifconfig eth0 <NEW IP ADDRESS> netmask <SUBNET MASK>." This is a
temporary IP assignment because the EN camera will lose this setting once you restart it.
.
Now you should be able to telnet to the EN cameras.
If you want to assign the new IP address permanently, you can use the "test_libcamera" utility. The
"test_libcamera" utility allows access to EEPROM, where all network settings are saved. After starting
"test_libcamera," you can use the following commands:
rc : read IP assignment (static or dhcp)
rp : read IP address
rs : read Subnet mask
rg : read Gateway
Change the IP assignment/IP address/SubnetMask/Gateway. Reboot the camera. The new IP address/
subnet mask are used at the next power-up.
Tutorial
wc : write IP assignment
wp : write IP address
ws : write Subnet mask
wg : write Gateway