Figure 11. Tls-300 Signal And Power Cable; Figure 12. Installing The Tls-300 Through The Mounting Pipe And Flange; Table 1 Light Sensor Cables - JAI VIS-CAM System TS-1327EN Installation Manual

Figure 11. TLS-300 signal and power cable.

3. Route the Traffic Light Sensor end of the TLS-300 signal and power cable through the mounting
pipe and the flange (see Figure 12)
4. Screw the flange onto the pipe, finger-tight, to allow
subsequent minor adjustment
5. Attach the cable connector to the Traffic Light Sensor
6. Attach the Traffic Light Sensor body to the flange and secure
it with the four Allen screws
7. Orient the Traffic Light Sensor such that the white reflectors
are parallel to the trigger plane with side B facing (visible from)
the trigger plane
8. Route the free end of the cable to the VIS J-Panel in accordance
with the local code requirements
9. Connect the color-coded wires to J-Panel connector X3 as described
in "X3, X7 Traffic Light Sensor " on page 22. Make sure that no power
is applied when performing any wiring operation.
Table 1
18
VIS-CAM System
Light Sensor Cables
PIN# Wire color
1 White/green
2 Green
3 Red/blue
4 Blue/red
5 -
6 Yellow
7 -
8 -
9 -
10 White
11 -
12 -
13 Brown
14 White/brown
15 Orange
16 White/orange
- Black
Installing the Vehicle Imaging Subsystem
Figure 12. Installing the TLS-300 through
the mounting pipe and flange.
Signal
Heater gnd
Heater gnd
Heater +24V dc
Heater +24V dc
nc
+24V dc
nc
nc
nc
Gnd
nc
nc
D1-
D1+
D0-
D0+
Shlds