JAI Pulnix TS-2030EN Series User Manual page 39

Page 27
TS-2030EN/TS-2076EN Series Progressive Scan Cameras
Type "en -v > version.txt." View the content of "version.txt" to see the firmware version
.
Enter the command "ps" to see what processes are running. If the "dhcpc" daemon is running, kill this
process. To do so, enter, for example, "kill <process_id>."
Enter the command "ifconfig" to see if the network is up and running.
Eth0 is the network interface of the EN camera. In the above example, the EN's network is set to the
following: IP address = 10.0.0.65. Subnet mask = 255.255.255.0.
If eth0 is not running or if you want to change to a different IP address, you can set the temporary
network setting just to enable a FTP, TELNET, or Ethernet connection
Tutorial