Bobbin Winding - ELNA Lotus Instruction Manual

w
z
t
x
c
t
q
r
e
y
r
u

Bobbin Winding

• Removing the bobbin
Gently slide the hook cover release button q to the
right and remove the hook cover plate w.
Lift out the bobbin.
q Hook cover release button
w Hook cover plate
• Setting the spool
z Turn the spool thread guide e as illustrated, and
the spool pin r will lift up.
WARNING
Do not lean over the top of spool pin when turning the
spool guide. The spool pin pops up and it may strike
your face.
e Spool thread guide
r Spool pin
x Place a spool of thread on the spool pin with the
thread running off counterclockwise.
Draw the thread from the spool about 4˝ (10 cm) of
thread. Attach the large spool holder t.
t Large spool holder
y Slit
NOTE:
If there is a slit y on the spool of thread, be sure to
place the spool with the slit end up.
c Press the spool holder t firmly against the spool
of thread, and then push down the spool pin r to
lower the spool until it is locked in the bottom.
* The small spool holder u is used with narrow or
small spools of thread.
u Small spool holder
NOTE:
If a rimless spool may not let thread out smoothly,
place the spool on the spool pin in up position and do
not use the spool holder so the spool can rotate freely.
24