Table of Contents
Advertisement
z
x
b
v
z
x
c
c
n
m
Winding the Bobbin
z Pull the handwheel out.
x Draw the thread from the spool.
Guide the thread around the bobbin winder
thread guide.
c Insert the thread through the hole in the bobbin
from the inside to the outside.
Put the bobbin on the bobbin winder spindle.
v Push it to the right.
b With the free end of the thread held in your
hand, depress the foot control.
Stop the machine when it has made a few
turns, and cut the thread close to the hole in
the bobbin.
n Depress the foot control again.
When the bobbin is fully wound, stop the
machine.
Return the bobbin winder spindle to its original
position by moving the spindle to the left, and
cut the thread.
m Push the handwheel back into the original
position.
NOTE:
Return the bobbin winder spindle when the
machine stops.
Threading Bobbin Case
z Place the bobbin into the bobbin case.
Make sure the thread unwinds in the direction
of arrow.
x Pull the thread into the bobbin case slot.
c Draw the thread under the tension spring and
into the delivery eye.
* Leave about 10 cm (4˝) of free thread.
8
Advertisement
Table of Contents
