Control Modes; One Expression 5000 (Built-In Programs); Multiple Expression 5000S (Master/Slave Control) - SHOWTEC Expression 5000 Product Manual

Control Modes

There are 3 modes:
One Expression 5000
1. Fasten the effect light onto firm trussing. Leave at least 0,5 meter on all sides for air circulation.
2. When the Expression 5000 is not connected by a DMX-cable, it functions as a stand-alone device.
Please see page 17 for more information about the built-in programs.
Multiple Expressions
1. Fasten the effect light onto firm trussing. Leave at least 0,5 meter on all sides for air circulation.
2. Use a 3-p XLR cable to connect the Expression 5000.
The pins:
3. Link the units as shown in (Fig. 4), Connect a DMX signal cable from the first unit's DMX "out"
socket to the second unit's "in" socket. Repeat this process to link the second, third, and fourth units.
You can use the same functions on the master device as described on page 17 (Built-in
This means on the master device you can set your desired operation Mode
and all slave devices will react the same as the master device.
• Select built-in programs
• Master/Slave
• DMX512 (12 Channels Advanced or 9 channel Basic)
(Built-in Programs)
(Master/Slave control)
1. Earth
2. Signal -
3. Signal +
Multiple Expressions (Master/Slave control)
10
Programs).
Fig. 4