Logging In For Configuration - Funkwerk TR200aw User Manual

5 Access and Configuration
86
User name Password
It is only possible to change and save configurations if you log in with the user name
. Access information (user names and passwords) can also only be changed if you log
in with the user name
plain text but only as asterisks. The user names, on the other hand, are displayed as plain
text.
The security concept of your device enables you to read all the other configuration settings
with the user name , but not the access information. It is therefore impossible to log in
with , read the password of the
make changes to the configuration.
Caution
All funkwerk devices are shipped with the same user name and password. As long as
the password remains unchanged, the devices are not protected against unauthorised
use. How to change the passwords is described in
Make sure you change the passwords to prevent unauthorised access to your device
If you have forgotten your password, you must reset your device to the ex works state,
which means your configuration will be lost.

5.2.2 Logging in for Configuration

Set up a connection to the device. The access options are described in
page 80.
Funkwerk Configuration Interface
Log in via the HTML surface as follows:
(1) Enter your user name in the User field of the input window.
(2) Enter your password in the Password field of the input window and confirm with Re-
turn or click the Login button.
The status page of the Funkwerk Configuration Interface opens in the browser.
Funkwerk Enterprise Communications GmbH
Authorisations
Read and change system variables, store configurations; use
Funkwerk Configuration Interface .
Read and write system variables (except passwords) (changes
are lost when you switch off your device).
Read system variables (except passwords).
. For security reasons, passwords are normally shown not in
user and subsequently log in with
Passwords
and
on page 108.
Access Options on
funkwerk TR200aw/bw