Software - KEB COMBICOM Installation Manual

3.

Software

The serial side supports:
• DIN66019 (RS 232)
• HSP5 (TTL level )
The type of interface is automatically detected.
If the DIN66019 protocol is used on the serial side, the "DIN66019 protocol USB" is only
physically converted to "DIN66019 protocol RS232" in the USB serial converter and the log
data remains unchanged.
If the HSP5 protocol is used on the serial side, the "DIN66019 protocol USB" is converted to
"HSP5 protocol TTL level" in the USB serial converter.
The following KEB services are supported (see protocol description HSP5):
0 Read / write the parameter value (extended set-addressing)
1 Read / write the parameter value (default set-addressing)
18 Read process data telegram type 3 (Timestamp, 2x32, 2x16 Bit)
No automatic baud rate search is supported. The baud rate is adjusted via the used program
e. g. The baud rate can be adjusted in the range of 2400 Baud...115.2 kBaud.
The default value of 38.4 HSP5 kBaud should not be changed.
At DIN66019 on F5 the value of 9.6 kBaud should be used.
The baud rate of the connected unit (see unit parameter) and the driver setting for
the used COM port must be adjusted equal.
Software
GB -7