Fuses; Electrical Output Terminals; Glove Box/Tools - Arctic Cat 2015 WILDCAT TRAIL/XT Operator's Manual

1. Position the vehicle on a level floor
so the headlights are approximately
6.1 m (20 ft) from an aiming surface
(wall or similar aiming surface).

NOTE: There should be an aver-
age operating load on the vehicle
when adjusting the headlight aim.
2. Measure the distance from the floor
to the mid-point of each headlight.
3. Using the measurements obtained in
step 2, make horizontal marks on the
aiming surface.
4. Switch on the lights. Make sure the
HIGH beam is on. DO NOT USE
LOW BEAM.
5. Observe each headlight beam aim.
Proper aim is when the most intense
beam is 5 cm (2 in.) below the hori-
zontal mark on the aiming surface.
6. To adjust the headlights, remove the
front grill and loosen the adjustment
screw. After proper adjustment is
achieved, tighten the cap screw to 60
in.-lb.

Fuses

The fuses are located in a power distribu-
tion module under the driver's seat. If
there is any type of electrical system fail-
ure, always check the fuses first.

NOTE: To remove the fuse, com-
press the locking tabs on either
side of the fuse cover and lift out.
50
Always replace a blown fuse with a
fuse of the same type and rating. If
the new fuse blows after a short
period of use, consult an authorized
Arctic Cat dealer immediately.
Electrical Output
0748-285
Terminals
Two output terminals for electrical acces-
sories are located on the center and rear
wiring harnesses. One accessory plug is
located under the driver's seat.

NOTE: The rear output terminal is
located above the air box
Always use electrical accessories
less than 180W.

Glove Box/Tools

This vehicle has a glove box in the dash-
board.
A basic tool kit (located under the operator
seat) is provided with this vehicle. Maintain
the tool kit with the vehicle at all times.
CAUTION
CAUTION
3411-964
WT098A